Rockwell Automation 825-MDN Smart Motor Manager DeviceNet Communication Card User Manual - Manual (Page 55)

Publication 825-UM002A-EN-P - December 2000
A-33
Instance Attributes
Attribute
ID
Access
Rule
Name (param #) Data
Type Min/Max Default Description
1 Get num Attributes USINT See Run/Stop Event Matrix
2 Get Attributes Array of
USINT List of Attributes supported by Control
Supervisor
10 Get Faulted/Trip (#211) BOOL 0…1 0 1=Fault Latched
0=No Faults present
11 Get Warning (#212) BOOL 0…1 0 1= Warning (not latched)
0=No Warnings present
12 Get/Set FaultRst (#154) BOOL 0…1 0 0 -> 1 = Fault Reset
0 = No Action
*13 Get FaultCode (#213) UINT 0…8116hex 0 In Faulted state, FaultCode indicates the
fault that caused the transition to
Faulted. If not in Faulted state, FaultCode
indicates the fault that caused the last
transition to the Faulted state.
Fault codes are listed in appendix C
*14 Get WarningCode (#214) UINT 0…8116hex 0 In Warning state, WarningCode
indicates the warning that caused the
transition to Warning. If not in Warning
state, WarningCode indicates the
warning that caused the last transition
to the Warning state.
Warning codes are listed in appendix C