Ce conformity – Rockwell Automation 20G PowerFlex 755 IP00 NEMA/UL Open Drive - Frames 8-10 User Manual
Page 23
Rockwell Automation Publication 750-IN020C-EN-P - May 2012
23
PowerFlex 755 IP00, NEMA/UL Open Type Drive
CE Conformity
Compliance with the Low Voltage Directive and Electromagnetic Compatibility
Directive has been demonstrated using harmonized European Norm (EN)
standards published in the Official Journal of the European Communities.
PowerFlex 750-Series drives comply with the EN standards listed below when
installed according to this document.
CE Declarations of Conformity are available online at:
www.rockwellautomation.com/products/certification/
Low Voltage Directive (2006/95/EC)
•
EN 61800-5-1 Adjustable speed electrical power drive systems – Part 5-1:
Safety requirements – Electrical, thermal and energy.
EMC Directive (2004/108/EC)
•
EN 61800-3 Adjustable speed electrical power drive systems – Part 3:
EMC product standard including specific test methods.
General Considerations
•
For CE compliance, drives must satisfy installation requirements related to
both EN 61800-5-1 and EN 61800-3 provided in this document.
•
PowerFlex 750-Series AC Drives comply with the EMC requirements of
EN 61800-3 when installed according to good EMC practices and the
instructions provided in this document. However, many factors can
influence the EMC compliance of an entire machine or installation, and
compliance of the drive itself does not ensure compliance of all
applications.
•
PowerFlex 750-Series drives are not intended to be used on public low-
voltage networks which supply domestic premises. Without additional
mitigation, radio frequency interference is expected if used on such a
network. The installer is responsible to take measures such as
supplementary line filters and enclosures to prevent interference, in
addition to the installation requirements of this document.
•
Requirements for supplementary mitigation related to specific high
frequency emission limits are provided in
IMPORTANT
Additional palm safe shield(s) are required for operator safety and CE
conformance.