Rockwell Automation 20G PowerFlex 755 IP00 NEMA/UL Open Drive - Frames 8-10 - Manual (Page 43)

Rockwell Automation Publication 750-IN020C-EN-P - May 2012 43
PowerFlex 755 IP00, NEMA/UL Open Type Drive
4. Swing the Control Pod into the converter assembly and tighten the captive
screws on the back panel.
5. Insert the two position connector of the single-bay 24V wire harness into
terminal P14 on the Fiber Interface Board.
6. Connect one end the fiber-optic cable to P1 (INV1) on the Fiber Interface
Board.
IMPORTANT Minimum inside bend radius for fiber-optic cable is
50 mm (2 in.). Any bends with a shorter inside
radius can permanently damage the fiber-optic
cable. Signal attenuation increases as inside bend
radius is decreased.
T20 or F - 6.4 mm (0.25 in.)
1.8 N•m (16 lb•in)
50 mm
(2 in.)
P1
INV1
P2
INV2
P3
INV3
P14
P13 Fiber
Interface Board
➌
➊
➋