Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 User Manual
Page 122
Publication 1404-UM001D-EN-E - October 2004
5-8 Setpoint Programming and Operation
34
Setpoint #1 time accumulator
Seconds
•
•
•
35
Setpoint #2 time accumulator
•
•
•
36
Setpoint #3 time accumulator
•
•
•
37
Setpoint #4 time accumulator
•
•
•
38
Setpoint #5 time accumulator
•
•
•
39
Setpoint #6 time accumulator
•
•
•
40
Setpoint #7 time accumulator
•
•
•
41
Setpoint #8 time accumulator
•
•
•
42
Setpoint #9 time accumulator
•
•
•
43
Setpoint #10 time accumulator
•
•
•
44
Voltage Sag
(1)
(2)
Volts
•
•
45
Voltage Swell
(1)
(2)
•
•
46
Transient detected
(2)
-
•
47
Avg IEEE THD V
%
•
•
•
48
Avg IEEE THD I
•
•
•
49
Avg IEC THD V
•
•
•
50
Avg IEC THD I
•
•
•
51
Avg Crest Factor V
-
•
•
•
52
Avg Crest Factor I
•
•
•
(1)
A setpoint activates when the magnitude of any phase passes the activation limit and releases when all
phases pass the release limit in the appropriate direction for the setpoint evaluation condition.
(2)
These setpoint types apply only to the applicable Powermonitor 3000 models and will appear as "inactive" on
other models.
Table 5.2 Setpoint Types
Setpoint Type
Description
Units
M4,
M5
M6
M8