Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 353)

Publication 1404-UM001D-EN-E - October 2004
Index 5
symmetrical component analysis 3-5
system clock sample applications C-2
date and time summary C-17
EtherNet/IP and ControlLogix C-7
PLC-5 controller using Remote I/O C-6
RSLinx DDE/OPC and MicroSoft Excel
C-12
SLC 500 controller and RS-485
communications C-2
T
theory of setpoint operation 5-1
tif 8-8
time of use 7-16
configuring the log 7-17
hours selection 7-16
reading the log 7-18
transient analysis configuration 8-19
transient detection metering and capture
8-18
clear command 8-24
configuration 8-19
reading capture data 8-21
reading metering data 8-20
U
under reverse setpoint 5-4
underforward setpoint 5-3
user-configured data table setup using
ControlLogix and EtherNet/IP
C-27
sample program operation C-27
V
viewing metered data 3-3
voltage current and frequency results
3-4
W
writing data 4-19
writing setpoint configuration using
comms 5-11