Mounting – Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions User Manual
Page 14
Advertising
Mounting
Mounting the Isolated Barrier
Snap the device onto the DIN mounting rail in a
vertical downward movement. See
figure below.
Mounting the Terminal Blocks
The insulation of the removable terminal blocks protect against direct contact. If you
replace the terminal blocks, observe the rated insulation voltage. If the rated voltage
greater than 50 V AC, proceed as follows:
1.
Switch off the voltage.
2.
Connect the terminal blocks or disconnect the terminal blocks.
CORRECT: Device snapped on vertically.
INCORRECT: Device snapped on from the side.
Can damage the contacts and cause the device to fail.
Bul. 937
C HART Loop Converter Installation Instructions
12
Advertising