Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions - Manual (Page 32)

Bul. 937C HART Loop Converter Installation Instructions
Editing device data: Input
Selecting an Assignment
The values of the selected HART variable (PV, SV, TV, QV) are shown on the current
output. The number of available variables depends on the HART field device. When
selecting
disabled, the downscale fault current of 0 mA or 2 mA is constantly present at
the current output, depending on the characteristic.
1. Select the desired HART variable using the  or  buttons.
2. Confirm your selection with OK.
▼
Iout2
OK →
← ESC
▼
Iout3
▼
Rel1
Rel2
OK →
← ESC
down
up
▼
hold
▼
OK →
← ESC
▲ ▼
OK →
← ESC
End Value see section
Fault Current
same as Iout1
same as Iout1
30