Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions - Manual (Page 49)

Menu Parameters Default setting Custom value
Output --- Iout3 Assignment disabled
Characteristic 4 - 20 NE43
Start value 0.000
End value 100.0
Fault current down
Output --- Rel1 * Trip value On (selected)
Trip value --- Assignment disabled
Trip value --- Min/Max min
Trip value --- Trip point 80.00
Trip value --- Hysteresis 10.00
Trip value --- Operating mode passive
Trip value --- Restart inhibit OFF
Trip value --- Response delay 0 s
Fault message not selected
Output --- Rel2 * Trip value On (selected)
Trip value --- Assignment disabled
Trip value --- Min/Max min
Trip value --- Trip point 80.00
Trip value --- Hysteresis 10.00
Trip value --- Operating mode passive
Trip value --- Restart inhibit OFF
Trip value --- Response delay 0 s
Fault message not selected
Editing device data: Default settings
Bul. 937C HART Loop Converter Installation Instructions
47
Service Language ENG
Password OFF