Resetting the device to factory settings – Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions User Manual
Page 44
Bul. 937C HART Loop Converter Installation Instructions
To protect parameterization from unauthorized changes, you can enable
password protection. Information about password protection see chapter 3.5.2.
1.
Use the or buttons to select the desired setting.
2.
To enable password protection, select
On Password.
3.
Confirm your selection with
OK.
4.
To disable password protection, select
Off Password.
5.
Confirm your selection with
OK.
Resetting the Device to Factory Settings
1.
Use the or buttons to select
On Reset.
On Reset flashes.
2.
Confirm your selection with
OK.
The device is reset to factory settings. All entries you have defined
in parameterization mode will be lost.
Use the or buttons to display the
version.
The software version of the device software is displayed.
Activating Password Protection
Displaying the Software Version
42