Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions - Manual (Page 21)

Parameterization Mode
After being switched on, the device is in display mode. If you have password
protection enabled, you must enter the password every time you transition from
display mode to parameterization mode.
Calling up Parameterization Mode
Press the OK and ESC buttons simultaneously for approx. 1
second.
The device changes from display mode to parameterization mode.
Exiting Parameterization Mode
1. Press the ESC once or multiple times. The number of times depends on which menu
level you are in.
The device changes from parameterization mode to display mode.
2. If you have not pressed a button for 10 minutes in parameterization mode, the device
switches back automatically to display mode.
▼ ▲
▼ ▲
▼
HARTcom
Unit
Main menu
Output
Service
Display mode
parameterization mode
OK + ESC (simultaneously for 1 s) →
← ESC
Bul. 937
C HART Loop Converter Installation Instructions
19 18 18