Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions - Manual (Page 42)

Bul. 937C HART Loop Converter Installation Instructions
Calling up a Fault Message
1. Use the  or buttons to select the Fault message menu.
2. If the fault message menu is activated, press the OK button once.
The Restart inhibit submenu is displayed.
3. If the fault message menu is not activated, press the OK button twice.
The Restart inhibit submenu is displayed. The Fault message menu is
activated and is marked as On.
The restart inhibit is used to prevent momentary trip value violations from not being
noticed by operating personnel.
1. Use the  or buttons to select On.
2. Confirm your selection with OK.
The relay status is retained after switching the relay.
3. If you would like to reset the relay status, press the ESC or
button or restart the device.
The relay is reset. Exception: there is a fault message.
OK →
← ESC
On
OFF
▼
OK →
← ESC
Restart Inhibit Fault (On)
Fault Message
Activating the Restart Inhibit
40