Rockwell Automation 937CU-AIHLP-DC1 HART Loop Converter Installation Instructions - Manual (Page 5)

Reference to further documentation
Laws, standards, or directives applicable to the intended use must be observed. In
relation to hazardous areas, Directive 1999/92/EC must be observed.
The corresponding data sheets, declarations of conformity, EC-type-examination
certificates, certificates and Control Drawings if applicable (see data sheet) are
an integral part of this document. You can find this information under
www.ab.com.
Due to constant revisions, documentation is subject to permanent change. Please refer
only to the most up-to-date version, which can be found under www.ab.com.
Marking
Intended Use
The devices are only approved for appropriate and intended use. Ignoring these
instructions will void any warranty and absolve the manufacturer from any liability.
The device must only be operated in the ambient temperature range and at
the relative humidity (non-condensing) specified.
The devices are used in Control &Instrumentation (C&I) technology for the galvanic isolation
of C&I signals such as 20 mA and 10 V standard signals or alternatively for adapting or
standardizing signals. Devices that incorporate intrinsically safe circuit are used for
operating intrinsically safe field devices in hazardous areas.
HART Loop Converter
Certification under Pepperl+Fuchs GmbH
Lilienthalstrasse 200, 68307 Mannheim, Germany
KFD2-HLC-Ex1.D.2W (937CU-AIHLP-DC1)
BASEEFA 07 ATEX 0174 , for additional certifications, see www.ab.com
E II (1)GD [Ex ia] IIC, [Ex iaD]
Pepperl+Fuchs Statement of Conformity
E II 3G Ex nA II T4 X
Bul. 937
C HART Loop Converter Installation Instructions
3