Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 19)

Publication 1794-UM001G-EN-P - January 2007
Directly Connect to the Controller via the Serial Port 19
4. Specify the serial port settings:
a. From the Comm Port drop-down list, select the serial port (on
the workstation) that the cable is connected to.
b. From the Device drop-down list, select Logix 5550-Serial Port.
c. Click Auto-Configure.
5. Does the dialog box display the following message:
Auto Configuration Successful!
Then click Close.
If: Then:
Yes Click OK.
No Go to step 4. and verify that you selected the correct Comm Port.