Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 95)

Publication 1794-UM001G-EN-P - January 2007
Configure PhaseManager 95
Equipment Phase
Instructions The controller supports several instructions to support equipment
phases. The instructions are available in ladder diagram (LD) and
structured text (ST).
For more information… The PhaseManager User Manual, LOGIX-UM001 provides information
on how to design, configure, and program, and phase manager
application.
If you want to: Use this instruction:
signal a phase that the state routine is complete so go to the
next state PSC
change the state or substate of a phase PCMD
signal a failure for a phase PFL
clear the failure code of a phase PCLF
initiate communication with RSBizWare Batch software PXRQ
clear the NewInputParameters bit of a phase PRNP
set up breakpoints within the logic of a phase PPD
take ownership of a phase to either:
• prevent another program or RSBizWare Batch software
from commanding a phase
• make sure another program or RSBizWare Batch software
does not already own a phase
PATT
relinquish ownership of a phase PDET
override a command POVR