Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 61)

Publication 1794-UM001G-EN-P - January 2007
Place, Configure, and Monitor I/O 61
Configure Distributed I/O
on DeviceNet To communicate with the I/O modules over Device, you add the
DeviceNet bridge to the I/O Configuration folder of the controller.
You define a scanlist within the DeviceNet adapter to communicate
data between devices and the controller.
For more information... See DeviceNet Communication Modules in Logix5000 Control Systems
User Manual, DNET-UM004.
…you build the I/O configuration in this order
For a typical distributed I/O network…
device device device device
single network
device card controller
device
linking
device
device device device
linking
device
device device
several smaller distributed networks (subnets)
Add the local scanner module.
card controller