Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 22)

Publication 1794-UM001G-EN-P - January 2007
22 Communicate over Networks
This chapter summarizes the FlexLogix controller’s
communications capabilities:
EtherNet/IP For EtherNet/IP communications, install a 1788-ENBT communication
card in your FlexLogix controller.
Use these software products when you use a FlexLogix controller on
EtherNet/IP:
For this information: See:
EtherNet/IP 22
ControlNet 25
DeviceNet 28
Serial 31
DH-485 39
Third Party 42
See:
• EtherNet/IP Modules in Logix5000
Control Systems User Manual,
ENET-UM001
• EtherNet/IP Web Server Module
User Manual, ENET-UM527
• EtherNet/IP Performance
Application Guide, ENET-AP001
• Logix5000 Controllers Design
Considerations Reference Manual,
1756-RM094
• EtherNet/IP Daughtercard
Installation Instructions,
1788-IN054
Software Use Required/optional
RSLogix 5000 programming
software Use this to configure the
FlexLogix project and define
EtherNet/IP
communications. Required
BOOTP/DHCP Utility This utility comes with
RSLogix 5000 software. Use
this utility to assign IP
addresses to devices on an
EtherNet/IP network. Optional
RSNetWorx for EtherNet/IP Use this software to
configure EtherNet/IP
devices by IP addresses
and/or host names. Optional