Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 94)

Publication 1794-UM001G-EN-P - January 2007
94 Configure PhaseManager
Manually change states
RSLogix 5000 software has a window that lets you monitor and
command an equipment phase.
Compare PhaseManager to
Other State Models This table compares PhaseManager’s state model to other common
state models:
Minimum System
Requirements To develop PhaseManager programs, you need:
• FlexLogix controller with firmware revision 15.0 or later
• communication path to the controller
• RSLogix 5000 software version 15.0 or later
To enable PhaseManager support, you need the full or professional
editions of RSLogix 5000 software or the optional PhaseManager
add-on (9324-RLDPMENE) to your RSLogix 5000 software package.
State that the equipment phase is in right now
To manually change states:
1. Take ownership of the equipment phase.
2. Give a command.
S88 PackML PhaseManager
Idle Starting
⇒ Ready
Resetting
⇒ Idle
Running
⇒ Complete
Producing Running
⇒ Complete
Pausing
⇒ Paused
Standby subroutines, breakpoints, or both.
Holding
⇒ Held
Holding
⇒ Held
Holding
⇒ Held
Restarting none Restarting
Stopping
⇒ Stopped
Stopping
⇒ Stopped
Stopping
⇒ Stopped
Aborting
⇒ Aborted
Aborting
⇒ Aborted
Aborting
⇒ Aborted