Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module - Manual (Page 14)

14 Publication 1756-UM525A-EN-P - June 2003
Chapter 2 Installing the 1756-HYD02 Module
Installing the Module You can install or remove the module while chassis power is applied.
1. Align circuit board with top and bottom chassis guides.
2. Slide module into chassis until module tabs ‘click’.
ATTENTION
The module is designed to support Removal and Insertion Under
Power (RIUP). However, when you remove or insert an RTB with
field-side power applied, unintended machine motion or
loss of process control can occur. Exercise extreme caution
when using this feature.
20861-M
Printed Circuit Board
20862-M
Locking Tab