Configuring the axes features – Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module User Manual
Page 36
Advertising
36
Publication 1756-UM525A-EN-P - June 2003
Chapter 3 Configuring the 1756-HYD02 Module
Configuring the
Axes Features
You must create an axis before you can associate it with a channel on the
1756-HYD02 module.
1.
Create the new axis tag as shown below.
2.
Access the axis properties as shown below.
Click on New Axis to create a new axis tag that
will contain the axis data. The New Tag pop-up
screen appears, as shown below.
The new axis tag must be:
² named
² of the AXIS_SERVO data type
² of the controller scope
A. Associate the channel(s) with the new
axis tag.
B. Click on the ellipsis (. . .) to access the
axis properties wizard.
Advertising