Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module User Manual
Page 17
Publication 1756-UM525A-EN-P - June 2003
17
Installing the 1756-HYD02 Module Chapter 2
Spring Clamp
1.
Insert the screwdriver into the outer hole of the RTB.
2.
Insert the wire into the open terminal and remove the screwdriver.
Recommendations for Wiring Your RTB
TIP
Consider the following when wiring your RTB:
• Begin wiring the RTB at the bottom terminals and move up.
• Use a tie to secure the wires in the strain relief area of the RTB.
• The jumper bar part number is 97739201. Contact your local
Rockwell Automation sales representative to order additional
jumper bars, if necessary.
• Order and use an extended-depth housing, that is cat.
no.1756-TBE, for applications that require heavy gauge wiring. For
more information, see page 24.
20860-M
Strain relief area