Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module - Manual (Page 18)

18 Publication 1756-UM525A-EN-P - June 2003
Chapter 2 Installing the 1756-HYD02 Module
Wiring the
1756-HYD02 Module Use the wiring example in Figure to wire to your module.
+OUT-0
-OUT-0
+ENABLE-0
-ENABLE-0
DRVFLT-0
CHASSIS
IN_COM
HOME-0
REG24V-0
REG5V-0
+OK
CHASSIS
+INT-0
-INT-0
+RET-0
-RET-0
LDT CMN
CHASSIS
+OUT-1
-OUT-1
+ENABLE-1
-ENABLE-1
DRVFLT-1
CHASSIS
IN_COM
HOME-1
REG24V-1
REG5V-1
-OK
CHASSIS
+INT-1
-INT-1
+RET-1
-RET-1
LDT CMN
CHASSIS
General cable C0720
To valve driver/amplifier
To home
limit switch
To E-stop relay coil
To hydraulic control unit
or
To valve or pump
To LDT
To registration
sensor
1. This is a general wiring example illustrating Axis 1 wiring only. Other
configurations are possible with Axis wiring identical to Axis 1.
2. Make sure that any transducer connected to the 1756-HYD02 module
uses an external interrogation signal.
3. Do not exceed the specified isolation voltage between power sources.
NOTES:
43394
General cable C0721
General cable C0720
General cable C0720
General cable C0722
General cable C0720