Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module - Manual (Page 7)

7 Publication 1756-UM525A-EN-P - June 2003 7
Preface
Using This Manual This preface describes how to use this manual.
Who Should Use This
Manual To effectively use this manual, you should be able to program and operate the
Rockwell Automation ControlLogix controllers to efficiently use your
ControlLogix Hydraulic Servo module. In this manual, we also refer to the
module as the 1756-HYD02 module.
If you need more information about programming and operating the
ControlLogix controllers, refer to the Logix5000 Controller User Manual,
publication number
1756-UM001 .
The Purpose of This Manual This manual describes how to set up, configure and troubleshoot your
1756-HYD02 module. The following table lists describes each section in this
manual:
If you are looking for this information: See this section
Description of the module and what it does. Chapter 1
What is the 1756-HYD02 Module?
Step by step description of how to install and
wire the module. Chapter 2
Installing the 1756-HYD02 Module
Description of how to use RSLogix 5000
programming software to configure the
module. Chapter 3
Configuring the 1756-HYD02 Module
Complete listing of the module’s features,
including the general module features and
features that specifically affect the data
coming from axes connected to either of the
module’s channels. Chapter 4
Using the 1756-HYD02 Module Features
Description of how to troubleshoot any
problems with the module, including the use
of status indicators on the module and
software fault messages in RSLogix 5000. Chapter 5
Troubleshooting the 1756-HYD02 Module
Specifications for the module. Appendix A
Specifications