Rockwell Automation 1770-HT8 SMART TRANSMITTER - Manual (Page 28)

Installing the Smart Transmitter Interface
Products
Chapter 2
2-3
Mount the Terminal Blocks in the same equipment cabinet as the Analog
I/O modules to which they will be connected. This ensures the integrity of
the 4-20 mA analog signal being received by the Analog I/O module.
Each unit of the Smart Transmitter Interface is equipped with two plastic
feet designed to attach to an EN 50 022 or EN 50 035 DIN rail. Using
these feet, clip the unit(s) to the DIN rail in the desired position
(Figure 2.1). The units can be mounted in any orientation—horizontally,
vertically, diagonally, etc.
Figure 2.1
Mounting on a DIN Rail
90037
Foot
DIN Rail
To release the feet from the rail, press on the plastic as shown in Figure 2.2
so that the clip is pulled back far enough to release the unit.
Figure 2.2
Releasing From a DIN Rail
90038
Foot
DIN Rail
Press Here
Mounting Smart Transmitter
Interface Products in a Cabinet