Rockwell Automation 1770-HT8 SMART TRANSMITTER - Manual (Page 36)

Installing the Smart Transmitter Interface
Products
Chapter 2
2-11
Marking the Terminal Block Labels
On the label on top of each Terminal Block is a place in the lower left hand
corner to record how you have configured the board address jumpers. The
jumper address configuration options for the unit are listed (3 options for
the 16 channel block and 4 for the eight channel block). Mark the box to
indicate which configuration you have used for this Terminal Block. (See
Figure 1.2 and 1.3.) Use a pencil so you can erase the marking if you
change the configuration.
As shown in Figure 1.10, a Terminal Block can be connected to Analog
I/O devices such as the 1771 IFE module, and to HART field devices. In
addition, a hand held terminal can be connected to the Terminal Block for
communication with HART field devices.
Connecting the Terminal
Blocks to I/O and HART Field
Devices