Rockwell Automation 1770-HT8 SMART TRANSMITTER - Manual (Page 59)

Configuring the Communications
Controller
Chapter 3
3-4
Configure Basic Parameters
2. Each time you press the VIEW button, the parameter number in the
left display advances, and the parameter’s current setting appears in
the right display.
Press the VIEW button as often as necessary or hold it down until the
desired parameter is reached.
3. Once the desired parameter is displayed, press the DATA button to
cycle through the available settings.
4. When you have reached the desired data setting, you can press VIEW
to display the next parameter and its current setting or go to step 7 to
save the change and exit configuration mode.
Repeat steps 2 through 4 until the basic parameter settings meet your
requirements.
Configure Advanced RSĆ232C Parameters
5. To enter the sub-menu press VIEW until parameter 9 appears in the
left display, then press DATA.
When you are in the sub-menu, the decimal to the right of the
parameter number lights up to distinguish this menu from the main
menu.
6. Use the VIEW and DATA buttons, as described in steps 2 to 4 to
review and modify the advanced parameter settings.
You can press EXIT to return to the main menu from the sub-menu,
if necessary. This does not end the configuration session and you may
go back to the sub-menu as described in step 5.
Save and Exit
7. To save the new data and exit configuration mode, press the VIEW
and EXIT buttons simultaneously. All parameters in both the main
menu and the sub-menu will be saved in non-volatile memory, and
the Controller will return to run mode. This ends the configuration
session.
If the save is successful, each display will show three dashes (see
Figure 3.2) for a period of two seconds. When the Communications
Controller returns to run mode, the new configuration takes effect
immediately, and the displays turn off.