Rockwell Automation 1794-OB16D FLEX I/O Diagnostic Modules User Manual - Manual (Page 49)

47 Publication 1794-UM061A-EN-P - July 2006
Chapter
5
Configure FLEX I/O Digital Modules on a
DeviceNet Network
How to Use This Chapter
This chapter provides basic information on how to use a 1794-ADN FLEX
I/O adapter to connect 1794 FLEX I/O digital modules to a DeviceNet
network.
Use RSNetWorx for DeviceNet software to add the 1794-ADN DeviceNet
adapter and FLEX I/O modules on a DeviceNet network.
To use the FLEX I/O adapter, cat. no. 1794-ADN:
Topic See Page
How to Use This Chapter 47
Add the Scanner to the I/O Configuration of
the Controller Using RSLogix 5000 Software 48
Determine the Address of DeviceNet Data 52
Tally Memory Requirements 54
If You Configure the Adapter Offline 55
Set the Address of the Adapter 56
Step: Page:
❑ Tally Memory Requirements 5-54
❑ As an option, give each module its own memory location (DINTs)
within the scanner. This may make your programming easier. Assign
one address for the 1794-ADN and all the modules that you connect to
it.
5-54
❑ If You Configure the Adapter Offline 5-55
❑ Set the Address of the Adapter 5-56