Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 10)

10 Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
Chapter 1 Getting Started
• Compatibility with IntelliCENTER software for parameter configuration
of the end device. A Bootstrap Protocol (BOOTP) server can be used to
configure the network address for the adapter.
• Status indicators that report the status of the end device communication,
the adapter, and network.
• Explicit Messaging support to the connected device.
Compatible Products At the time of publication, compatible products include the following:
• E3/E3 Plus Overload Relays
• 825-P Modular Protection System
Required Equipment This section lists the equipment shipped with the adapter and what supplies you
need.
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes the following:
• (1) 2100-ENET Adapter
• (1) 0.3 m 2100-ENET adapter to DeviceNet Cable to connect the end
device to the adapter
User-supplied Equipment
To install and configure the adapter, you must supply the following:
• A small flathead screwdriver
• Ethernet cable - refer to the EtherNet/IP Network Infrastructure
Guidelines, publication
ODVA, Pub. 35
• Ethernet switch – refer to the Ethernet Design Considerations Reference
Manual, publication
ENET-RM002
• Configuration tool, such as the following:
–
IntelliCENTER software, version 3.00.01 or later
– BOOTP Server, version 2.1 or later (network setup only)
• Controller configuration software (such as RSLogix 5 or RSLogix 500
software or the Studio 5000 environment)
• A personal computer connection to the EtherNet/IP network