Change an assigned ip, Address or enable bootp in the 2100-enet adapter – Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter User Manual
Page 21
Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
21
Configure the Adapter
Chapter 3
7.
In the Relation List window, select the node and click Disable BOOTP/
DHCP.
This disables the BOOTP/DHCP functionality in the 2100-ENET
adapter, permanently assigning the applied IP address.
8.
To save the configuration data, from the File menu, choose Save As and
provide an appropriate filename.
9.
Cycle power to the 2100-ENET adapter.
Upon powerup, the 2100-ENET adapter disables the BOOTP protocol
and responds to network traffic that is addressed to the assigned IP address
every time it powers up.
Change an Assigned IP Address or Enable BOOTP in the 2100-ENET
Adapter
1.
Connect your personal computer to the network to which the 2100-
ENET adapter is connected.
The adapter can be connected directly to your personal computer, if a
network does not exist.
2.
Start your BOOTP program.
TIP
This information is useful for future configuration changes that use the BOOTP
server program.
Do not apply power to the 2100-ENET adapter until directed to do so.