Reset the adapter, Update the adapter, Update the e3 plus or 825-p – Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter User Manual
Page 24: Reset the adapter update the adapter
24
Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
Chapter 3
Configure the Adapter
Reset the Adapter
Changes to some of the parameters in the E3 Plus or 825-P (for example, input
and output assemblies) require that the adapter is reset before the new settings
take effect. You can reset the adapter by power cycling the 2100-ENET adapter or
by clicking Reset Module in the E3 Plus or 825-P AOP.
When a Reset Module is issued, the 2100-ENET adapter immediately resets.
When this occurs, the E3 Plus or 825-P does not reset.
Update the Adapter
The adapter can be updated over the network. ControlFLASH™ software, a tool
provided by Allen-Bradley, is used for updating the adapter.
To obtain a update for this adapter, go
his site contains all firmware update files and
associated Release Notes that describe firmware update enhancements/
anomalies, how to determine the existing firmware revision, and how to update
by using ControlFLASH software.
Update the E3 Plus or 825-P
The E3 Plus or 825-P can be updated while connected to the adapter.
ControlFLASH software is used to update the E3 Plus or 825-P. There is a
specific update file for the E3 Plus or 825-P when updating is done while still
being connected to the adapter. The file has ‘via_2100-ENET’ in the title
(that is, E3_Plus_via_2100-ENET.msi).
To obtain the update for this adapter, go to
ATTENTION: Risk of injury or equipment damage exists. If the adapter is
transmitting control I/O to the end device, the end device can fault when you
reset the adapter. Determine how your end device responds before resetting a
connected adapter.