Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 15)

Rockwell Automation Publication 2100-UM006A-EN-P - July 2013 15
Install the Adapter Chapter 2
Connect the Adapter to the
Network Follow these steps to connect the adapter to the network.
1. Connect one end of an Ethernet cable to the network.
See following graphic for an example of wiring to an EtherNet/IP
network.
Connecting the Ethernet Cable to the Network
2. Route the other end of the Ethernet cable to the EtherNet/IP network
connector on the bottom of the 2100-ENET adapter.
Apply Power Connect 24V power to the DC+ connector on the bottom of the 2100-ENET
adapter. When power is supplied to the adapter for the first time, its topmost
status indicator is steady green or flashing green after an initialization. If it is red,
there is a problem. Refer to
Troubleshooting , Chapter 7 .
Start-up Status Indications
After power has been applied, the status indicators can be viewed on the front of
the 2100-ENET adapter (
Figure 2 ).
Figure 2: 2100-ENET Adapter
Ethernet
Switch
Controller
(ControlLogix shown with
1756-ENBT bridge)
2100-ENET Adapter
Status Indicators