Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 18)

18 Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
Chapter 3 Configure the Adapter
Configure the Adapter by Using the BOOTP Server
Connect your personal computer to the network the 2100-ENET adapter is
connected. It can be connected directly to your personal computer, if a network
does not exist.
1. Start your BOOTP program.
ATTENTION: Do not apply power to the 2100-ENET adapter until directed to do
so.
TIP From the Tools menu, choose Network Settings. Verify that the Subnet Mask
and the Gateway Address match those of your network. If necessary, change
the values to match your network.