Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 19)

Rockwell Automation Publication 2100-UM006A-EN-P - July 2013 19
Configure the Adapter Chapter 3
2. Click OK.
3. Apply power to the non-configured 2100-ENET adapter.
The adapter immediately begins broadcasting its BOOTP message which
indicates it is available to have its address set. If the adapter does not
broadcast its BOOTP message, refer to the
Change an Assigned IP
Address or Enable BOOTP in the 2100-ENET Adapter section.
4. In the Request History area, double-click the desired node.
The New Entry dialog box appears.
Fill in the IP address, host, and description.