Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 28)

28 Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
Chapter 4 Configure the I/O
The RSLogix 5000 window reappears with the treeview in the left pane.
3. In the treeview, right-click the I/O Configuration folder and choose New
Module.
The Select Module dialog box appears.
4. Expand the Communications group to display all of the available
communication modules.
Bridge Select Module Dialog Box
5. From the list, select the EtherNet/IP network bridge used by your
controller and click Create.
In this example, we use a 1756-ENBT EtherNet/IP network Bridge (Series
A).
6. From the Select Major Revision dialog box, select the major revision of its
firmware and click OK.
7. Click OK.