Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 37)

Rockwell Automation Publication 2100-UM006A-EN-P - July 2013 37
Configure the I/O Chapter 4
6. Enter the IP address of the E3 Plus EtherNet/IP network adapter.
IP Address
7. Click Next.
8. Enter a value for the time between each scan of the adapter.
9. Make sure Inhibit Module is not checked.
Module Properties
Bit Contents
0 OutA
1 OutB
2 Fault Reset
3 Not Used
4 Not Used
5 Remote Reset
6 Not Used
7 Not Used
Byte Size Contents
2 Bytes Header information (Pad Word)
2 Bytes Header information (Pad Word)
2 Bytes Value of parameter pointed to by parameter #61
2 Bytes Value of parameter pointed to by parameter #62
2 Bytes Value of parameter pointed to by parameter #63
2 Bytes Value of parameter pointed to by parameter #64