Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 102)

5–15 Downloading/Uploading Message Files
Publication 2706-6.2
If you select Remote (Bridge), then you must specify the Local and
Remote Bridge Addresses.
Parameter Acceptable values
Local Bridge Address 0 to 376 (octal)
Remote Bridge Address 0 to 376 (octal)
The Local Bridge Address is the Data Highway address that you
assign to the module connecting the DH+ link on which your
programming computer resides to the Data Highway. This address
must match the settings of the DIP switches on the module.
The Remote Bridge Address is the Data Highway address that you
assign to the module connecting the DH+ link on which the PLC-5 to
which the DL40 is connected resides to the Data Highway. This
address must match the settings of the DIP switches on the module.
Setting Device Parameters for an Ethernet Network
Additional transfer parameters may be necessary when you select an
Ethernet communications device. For Ethernet devices, you must
specify the Routing, Pushwheel, and Channel.
Ethernet Parameters configuration screen
Parameter Acceptable values
Routing PLC 5E
5130-RM
5130-KA
Pushwheel 1 to 8
Channel 2
3