Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 135)

PLC-5 Data Pass–Through D–3
Publication 2706-6.2
Setup Communication files using the following Offline
Programming Software screens:
•
Download to DL40 (DH+ and Remote I/O) setup screens
•
Upload from DL40 (DH+ and Remote I/O) setup screens
Note: The DL40 must be operating in Block Transfer mode when
using the Pass-Through feature.
!
ATTENTION: Incorrect Address selection could
corrupt data in a non-DL40 device. Verify that the
correct Communication File is selected.
To access the setup parameters for file transfers, select the Transfer
menu on the initial Main Menu screen as shown below.
Moves cursor to desired function.
Home
CR
F1
End
Moves cursor directly to 1 st function - Download, etc.
Selects function highlighted by cursor.
Help
Moves cursor directly to last function -Quit.
↑ ↓
Communications
File Setup