Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 132)

ASCII Character Sets C–5
Publication 2706-6.2
International Character Set
To access the international character set, also called Latin Alphabet
No.1, use the [ALT] key in combination with the numeric keypad
section on your keyboard. Hold down the [ALT] key, then enter the
2-digit hexadecimal value found in the chart below. For example, to
enter &, you would hold down
[ ALT] then enter the value 26. The
normal corresponding ASCII character is displayed in the offline message
window when you release the [ALT] key. When you download the
message file to the DL40 Plus, the characters are displayed in the
international font. The international character set is not available with the
onboard editor.
Note: The International character set is only available on DL40 Plus
Dataliner message displays. The offline programmer displays a
warning message if you attempt to download an International
application to a standard DL40 message display.