Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 26)

2–4 Installing the Software
Publication 2706-6.2
Use the following procedure to install the basic Offline Programming
Software files on an IBM PC. Note that prompts appearing here
represent a typical PC. The prompts you see on your computer may
vary slightly from those shown here.
Note: Do not automatically install all of the program disks. First
determine the type of installation you require and install just the
programs required.
1. If running in a Windows environment, restart your computer in
DOS mode. Windows NT users need to restart their computers
with a Windows 95 or less operating system.
2. Start your computer and log on to the hard disk (normally you
will see the DOS prompt C:>).
Note: Depending on your installation, your DOS prompt may be
different.
3. Insert the DL40 Offline Programmer disk into the micro drive.
Most often this will be the A: drive.
4. At the DOS prompt (C:>), type:
A:INSTALL
↵
5. Follow the onscreen installation prompts until installation is
complete and the C:> prompt reappears. Note: If the Offline
Programming Software program is already on disk, you will be
able to overwrite the program during installation.
6. The installation procedure automatically creates a default
sub–directory which contains the Offline Programming Software
program. By default that directory is DL40. Change to that
directory by typing:
CD\DL40
↵
Basic Installation
(without PassThrough)