Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 93)

5–6 Downloading/Uploading Message Files
Publication 2706-6.2
You can upload one file at a time from a DL40 to the Offline
Programming Software. When you select Upload from DL40
(RS-232/RS-485), the Upload File from DL40 window appear.
Move the cursor to DL40 Port and press
[
↵
]. Select RS-232 or
RS-485 from the window and press [
↵
] . A message will flash
briefly to indicate that the Offline Programming Software is saving
the setup file.
Upload File (via RS-232)
To configure your computer’s communication port, select Configure
Port on the Upload to DL40 menu, then press
[
↵
] . Select COM1 or
COM2, press [
↵
] , specify your computer’s address (if using
RS-485), and select a baud rate in the Configure Port window.
Note: To change parity or data bits, return to the Develop→Ports
menu.
If necessary, you can select Directory to change the currently
selected data directory for the uploaded files.
Uploading a File
using RS-232 or RS-485