Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 96)

5–9 Downloading/Uploading Message Files
Publication 2706-6.2
Download (Remote I/O) screen – expanded
When the settings on the expanded Download (Remote I/O) screen
are configured, move the cursor to the Download FILENAME line
and press
[
↵
]. Answer Yes when asked if you want to start
downloading now. Before you download you will get one of the
following warnings, depending on the type and access settings of
your DH+ hardware device.
!
ATTENTION: Before the download begins, you will see
one of the following warnings. Which one you see depends
on the type and access settings of your DH+ or Ethernet
hardware device.
WARNING: Incorrect address selection could corrupt data
in a non-DL40 device. Verify that the correct
Communication File is selected.
WARNING: Incorrect address selection could corrupt data
in a non-DL40 device. Verify that the correct
Communication File is selected.
DH+ Network Access is set to Local.
WARNING: Incorrect address selection could corrupt data
in a non-DL40 device. Verify that the correct
Communication File is selected.
DH+ Network Access is set to Remote (Bridge)
– Local Address is __.
– Remote Bridge Address is __.
Be sure the selected communication file has the correct
address parameters, and change them if necessary before
continuing.
Note: When downloading via Remote I/O, Download Type is
automatically set to All. You can’t transfer Parameters only.