Brother MFC-730 - Manual (Page 215)

203
Using Remote Access Code
1 Dial your MFC phone number from a
touch tone phone.
2 Enter your Remote Control Access Code
(159 ) after the beep.
3 The MFC signals the kinds of messages
received:
1 long beep — Fax message(s)
2 long beeps — Voice message(s)
3 long beeps — Fax and Voice message(s)
No beeps — no messages
4 After 2 short beeps, enter a command.
5 Press 9 0 to reset the MFC when you
finish.
6 Hang up.
1 5 6
Retrieve all faxes press 2 , then
enter the number of remote fax
machine, and then
# # . After the
beep, hang up and wait.
Erase all fax messages press 3 .
Check Receiving Status
Press 9 7
then for Fax message, press 1 .
Voice message, press 2 .
1 long beep — received messages
3 short beeps — no messages
Change Answer Mode
Press 9 8
then for Message Manager (TAD mode),
press 1 .
Fax/Telephone (F/T), press 2 .
Fax Only, press 3 .
Exit Remote Operation
Press 9 0 .
M
ESSAGE
M
ANAGER
R
EMOTE
C
ONTROL
A
CCESS
C
ARD
Using Remote Access Code
1 Dial your machine phone number from a
touch tone phone.
2 Enter your Remote Control Access Code
(159 ) after the beep.
3 Your machine signals the kinds of messages
received:
1 long beep — Fax message(s)
No beeps — no messages
4 After 2 short beeps, enter a command.
5 Press 9 0 to reset your machine when you
finish.
6 Hang up.
4
Change Answer Mode
Press 9 8
then for TAD, press 1 .
Fax/Tel (F/T), press 2 .
Fax, press 3 .
Exit Remote Operation
Press 9 0 .
Change Remote Access Code
1 Press Menu , 1 , 8 , 3 .
2 Enter the 3-digit number. The cannot be
changed.
3 Press Set .
4 Press Stop to exit.
1
R
EMOTE
C
ONTROL
A
CCESS
C
ARD
(For MFC-730)
(For MFC-740)
➔
➔