Brother MFC-730 - Manual (Page 92)

80
C H A P T E R N I N E
Using access codes is easy. Sometimes you may want to choose from the
among several long distance carriers when you make a call; rates may
vary depending upon the time and destination. To take advantage of low
rates, you can store the access codes or long-distance carriers as One
Touch and Speed Dial numbers.
Tone/Pulse
If you have pulse dialling service, but need to send tone signals (for
telephone banking, for example), follow the directions below. If you
have touch tone service, you do not need this feature to send tone
signals.
1 Lift the handset.
2 Press # . Any digits dialled after this sends tone signals.
3 When you hang up, the machine returns to pulse dialling service.
Fax/Tel Mode
When you share one line for your telephone and fax machine, in the
Fax/Tel mode, the fax machine can determine whether an incoming call
is a fax or a telephone call.
Answering Calls with the Speaker Phone
(Only for MFC-740)
When the MFC rings, instead of lifting the handset, press
Speaker Phone . Speak clearly, toward the microphone. To end the
call, press Speaker Phone .
If you have a bad telephone line connection, the other party might hear
your voice echoed during the call. Hang up and try the call again —
OR— pick up the handset.
Tel Key (Only for MFC-730)
If you press Tel when you are talking lifting the handset with the other
end, you can hear the other end from machine’s monitor speaker, but the
other end cannot hear you.
See
“Select
Answer
Mode”
chap. 6