Brother MFC-730 - Manual (Page 90)

78
C H A P T E R N I N E
One Touch Dialling
1 Pick up the handset ––OR–– press Speaker Phone .
2 When you hear a dial tone, press the One Touch Dial key of the
location you want to call.
3 To hang up, replace the handset ––OR–– press Speaker Phone .
If you try to use a One Touch location with no number stored in it, you
hear a warning sound, and screen displays NOT ASSIGNED. The
display returns to normal after 2 seconds.
If you are sending a fax, press Start after pressing the One Touch Dial
key. If you picked up the handset, press Start when the receiving fax
machine answers with fax tones.
Speed Dialling
1 Pick up the handset ––OR–– press Speaker Phone .
2 When you hear a dial tone, press Speed Dial , then press the two-
digit Speed Dial number.
3 To hang up, replace the handset ––OR–– press Speaker Phone .
Mute
1 Press Mute to put a call on hold.
2 You can put down the handset without disconnecting the call.
3 Pick up the MFC’s handset or press Speaker Phone to release the
call from hold. Picking up an extension handset will not release the
call from hold.
Pause
Press Redial/Pause to insert a pause between digits to be dialled.
If your MFC is connected to a PABX, you may need to insert an
additional number prefix (e.g. “9”) and a “pause” before each fax or
telephone number to gain access to the outside line. When you press
Redial/Pause , a dash “-” will appear on the display. By storing a pause,
you can create a delay of 3.5 seconds.
See
“Storing
Speed Dial
Numbers”
chap. 8
See
“Storing One
Touch Dial
Numbers”
chap. 8