2 measuring – Metrohm 916 Ti-Touch User Manual

Page 268

Advertising
background image

27.2 Measuring

■■■■■■■■■■■■■■■■■■■■■■

252

■■■■■■■■

916 Ti-Touch

NOTE

Manual control can also be exited when a manual sequence has been
started but has not yet ended. The fact that a sequence has been
started in manual control can be recognized by the corresponding sym-
bol in the title line (see Chapter 6.2.3, page 32).

27.2

Measuring

Manual control

▶ Measure

Manual measurements can be carried out with the function [Measure].

Proceed as follows:

1 Select a sensor

■

Select the desired sensor from the sensor list.
All of the sensors available in the sensor list are displayed. Sensors
are defined under System

▶ Sensors.

■

Select the measuring input at which the sensor is connected.

2 Select a measuring mode

■

Select the desired measuring mode.
Only those measuring modes are displayed which are advisable
for the selected sensor.

Advertising