Metrohm 916 Ti-Touch - Manual (Page 28)

4.3 Connecting the propeller stirrer
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
916 Ti-Touch
4.3 Connecting the propeller stirrer
The 916 Ti-Touch has a built-in stirrer connector. You can connect the
802 Stirrer propeller stirrer to it.
Proceed as follows:
1 Plug in the connection cable of the 802 Stirrer propeller stirrer to the
stirrer connector of the Ti-Touch (2-11).
Figure 4 Connecting the propeller stirrer
2 Attach the electrode holder (6.2021.020) to the mounted support
rod (6.2016.050).
3 Insert the propeller stirrer 802 Stirrer without the stirring propeller
from above into the center opening of the electrode holder.
4 Plug the stirring propeller (6.1909.010) from below to the propeller
stirrer.