Metrohm 916 Ti-Touch - Manual (Page 91)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
10 Sensors
916 Ti-Touch
￭￭￭￭￭￭￭￭ 75
10 Sensors
Main dialog: System ▶ Sensors
This chapter describes how you can create a list of the sensors used in the
system.
Three standard sensors are defined in the sensor list: pH electrode,
Metal electrode and Temperature sensor. These sensors cannot be
deleted or renamed. A maximum of 25 additional sensors can be added to
these sensors.
For each sensor, the following data is displayed in the sensor list:
￭ Designation
￭ Type
– pH: pH electrode
– Metal: Metal electrode
– Temp.: Temperature sensor
￭ Measuring input/control device (only for intelligent sensors if they are
connected)
Intelligent sensors are also indicated by IS and are depicted in green let-
tering.
The following sensor data is stored in the list of sensors:
￭ Name
Each sensor in the system is identified by its unambiguous name.
￭ Calibration data (for pH sensors only)
￭ Calibration interval (for pH sensors only)
￭ Working life
￭ etc.