Banner SureCross DX80 Wireless Networks - Manual (Page 109)

109
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Rotary Dial Address Mode
Step 2 - Powering the Gateway and Channel Search Mode
To apply power to the Gateway or GatewayPro, connect the 10–30V dc cable as shown.
A Gateway runs Channel Search Mode on power up or when the Gateway’s Network ID is changed. Once Channel
Search Mode begins, the Gateway determines if its assigned Network ID is available for use or is already in use by
another radio network.
For example, if a Gateway powers up set to Network ID 2, Channel Search Mode begins running as shown below.
Wire No. Color Description
1 Brown 10–30V dc Input
2 White RS485 / D1 / B / +
3 Blue dc common
4 Black RS485 / D0 / A / −
5 Gray Comms Gnd
1. Apply power to the Gateway and set the rotary dial to a Network ID number (shown here as Network ID 2.
Channel Search Mode begins running. LED 1 is solid red and LED 2 is flashing yellow. The LCD displays START CHANNL SEARCH
MODE.
The selected Network ID (NID) is tested to determine availability. The test takes one minute to complete and counts down from 60
seconds. The LCD shows SEARCH NID 2 1M 0S. If the Network ID is not already in use, the LCD displays NID OK and enters RUN
mode.
2. If the Network ID is already in use by another DX80 Gateway device, an IN USE message displays. Use the left rotary dial to select
another ID.
3. After selecting a new Network ID, click button two once to restart Channel Search Mode.
The screen cycles between displaying the current Network ID setting and a new NID setting until either the left rotary dial is changed
to another Network ID or the test is aborted. (LED 1 is solid red and LED 2 flashes red.) Once a new Network ID is selected, Channel
Search Mode begins again.
4. Once in RUN mode, the LCD display shows the current I/O status of the Gateway.
The Gateway and GatewayPro start in *RUN mode. The LCD shows the current Network ID (NID), identifies the device, then beings
cycling through the I/O points (GatewayPro has no I/O points).
To cancel Channel Search Mode, double-click button two. The word ABORT displays on the LCD and both LEDs are solid red. The Gateway
enters RUN mode, operating on the Network ID chosen.
To ignore the Channel Search Mode results and use a Network ID that Channel Search Mode determined was in use, double-click button two.
The word IGNORE displays on the LCD and both LEDs are solid red. The Gateway enters RUN mode, operating on the Network ID chosen
despite being in use by another device.