Banner SureCross DX80 Wireless Networks - Manual (Page 33)

33
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Advanced Setup
Changing the IP address
Once logged into the system, use the page tabs at the top of the page to select the hierarchical path: System > Setup > Network. To change
the IP address, type in the new IP address and click the Change IP button. The IP address change activates when the Ethernet Bridge or
GatewayPro device reboots (power off, power on.)
IMPORTANT: Verify the new IP address is correct before cycling power to the device. Once the IP address is changed, you must enter in the
new IP address to access the Web page-based configuration screens. Write down the new IP address (and any other changed parameters on
this screen) or print this page and file for your record.
Communication Protocol
By default the Ethernet Bridge and GatewayPro systems communicate using Modbus/TCP, but the system can also use EtherNet/IP™. To
change the system to EtherNet/IP, log in using the following user name and password:
User name: root
Password: sxi
At the bottom of the System > Setup > Network page is a checkbox to enable EtherNet/IP. Only select this box if the GatewayPro system is
running on an EtherNet/IP network. This change cannot be enabled from a login other than the “root” login.
After selecting the EtherNet/IP Enabled checkbox, click the Set Ports button to save any changes made to the HTTP Port, Modbus Server
Port, Telnet Port, and EtherNet/IP Enabled box. As with the IP address change, cycle power to the Ethernet Bridge or GatewayPro to complete
this update. After the device powers up, the changes should be registered.
After changing the IP address of the Ethernet Bridge device, print this page for your
records.
Tip
To save the changes to the XML file, go to the System > Setup > Config File page and
click the Save button.
Changes made by clicking an Update or Change button are temporary until the changes
are saved permanently in the configuration file.
Tip