Banner SureCross DX80 Wireless Networks - Manual (Page 34)

34
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Advanced Setup
Manual Binding
Manually choosing the extended address code is particularly useful when replacing components of an existing wireless network. To determine
the existing extended address code, access the DINFO (Device Information) menu of either the existing Gateway or another Node in the
network. Follow the submenu structure to the XADR display for that device.
To Manually Bind a Gateway
1. Remove the Gateway’s top cover.
2. Move DIP switch 1 to the ON position to activate Extended Addressing Mode.
3. Apply power to the Gateway.
The Gateway’s LCD shows POWER, then RUN.
4. On the Gateway, single click button 1 to advance across the menus, stopping at the DVCFG menu.
The Gateway’s LCD shows (DVCFG).
5. Single click button 2 to select DVCFG. Single click button 1 to select from the available menu options, stopping at XADR.
6. Single click button 2 to enter the XADR menu.
AUTO is automatic binding mode and uses the Gateway’s serial number as the extended address code.
7. Single click button 1 to select manual mode.
8. Single click button 2 to enter manual mode.
MANUAL allows the user to manually enter an extended address code.
9. Single click button 2 to advance to the extended address code entry step.
Once in manual mode, use the right rotary dial to select the digits of the extended address code. The LCD shows SET XADR 000000.
10. Use the right rotary switch to begin setting the extended address code. Digit selection begins with the left most digit. After selecting
the first digit, single click button 1 to advance right to the next digit. All six digits must be filled, even if it is with leading zeros. For
example, to use 2245 as the code, enter 002245 into the device.
To use the Gateway’s serial number, enter 000000 as the extended addressing code.
11. Continue entering the code using a single click of button 1 to advance from left to right.
Upon reaching the sixth digit, the curser returns to the first digit.
12. Single click button 2 when code entry is complete.
The Gateway LCD displays the entered value for confirmation by showing CONFRM XADR, then repeating back your value.
13. Single click button 2 to save the code and exit the XADR menu.
When entering the extended address code, the digits auto fill with whatever position the rotary switch is currently in. For example, after entering
the 00 part of the extended address code 002245, the third digit auto fills with a 0 until the rotary dial is rotated to 2.
After manually changing the extended address code on a Gateway in an existing network, change the extended address code for all Nodes
in that network by either manually setting the code on all Node(s) or by beginning the automatic binding sequence on the Gateway and auto-
binding all the Node(s).