Banner SureCross DX80 Wireless Networks - Manual (Page 74)

74
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Maintenance and Repairs
DX80 Integrated Battery
To replace the lithium “D” cell battery in any integrated battery model:
1. Remove the four screws mounting the battery pack face plate to the body and remove the
face plate.
2. Remove the discharged battery and replace with a new battery. Only use a 3.6V lithium
battery from Xeno, model number XL-205F.
3. Verify the battery’s positive and negative terminals align to the positive and negative
terminals of the battery holder mounted within the case. The negative end is toward the
spring. Caution: There is a risk of explosion if the replacement battery is incorrect.
4. After replacing the battery, allow up to 60 seconds for the device to power up.
When removing the battery, press the battery towards the negative terminal to compress the
spring. Pry up on the battery’s positive end to remove from the battery holder. Properly dispose of
your used battery according to local regulations by taking it to a hazardous waste collection site,
an e-waste disposal center, or other facility qualified to accept lithium batteries.
As with all batteries, these are a fire, explosion, and severe burn hazard. Do not burn or expose
them to high temperatures. Do not recharge, crush, disassemble, or expose the contents to water.
Replacement battery model number: BWA-BATT-001. For pricing and availability, contact Banner
Engineering.